Custom Sheet Metal Fabrication for Residential HVAC & Ventilation
I fabricate custom ductwork, transitions, plenums, boots, and ventilation components for residential HVAC and ventilation projects across the Sea to Sky corridor.
What I do
- Custom duct transitions and offsets
- Supply and return ductwork
- Plenums, takeoffs, and boots
- Range hood and dryer vent ducting
- Mechanical ventilation components
Good-fit projects
- Residential renovations
- Custom homes
- HVAC retrofits
- Heat pump ductwork modifications
- Builder and HVAC contractor support
Off-the-shelf duct parts rarely fit older homes, tight mechanical rooms, or renovations where the framing has already been built. I fabricate the transitions, plenums, takeoffs, and fittings needed to connect and route residential HVAC and ventilation systems cleanly, sized to the actual space rather than forced to fit.
Where this matters
Custom fabrication is most useful when an existing duct layout was built around older equipment, when a renovation changes where ducting can run, or when a heat pump or new appliance needs a transition that no standard part provides. Getting these pieces right before walls and finishes close up avoids airflow problems and rework later.
Where I provide this service
I serve Squamish, Whistler, Pemberton, and nearby Sea to Sky communities. See service areas.
Related services
Frequently Asked Questions
What can you fabricate custom ductwork for?
I fabricate custom ductwork, fittings, transitions, plenums, boots, and ventilation components for residential HVAC and ventilation systems, including renovations, custom homes, and retrofits where off-the-shelf parts do not fit.
Do you support HVAC contractors and builders?
Yes. I provide custom sheet metal and ductwork support for HVAC installers, builders, and renovation contractors who need fabricated components or duct routing that fits site constraints.